Technical Support

Products

30 Dec 2009

Door locks do not function with EVO-CHR.

Symptom

The vehicle is equipped with keyless entry, but the door locks do not function with the remote-starter.


Cause

The EVO-CHR did not detect the factory key-fob during step 9 of the programming sequence.


Solution

During step 9 of the programming sequence:

If the vehicle is equipped with keyless entry:

  • Press either the LOCK or UNLOCK button on the factory keyless remote.
  • The LED will turn OFF to indicate that the programming is complete.
  • If the EVO-CHR is unplugged before this step is complete, restart the programming sequence from step 1.


If the vehicle is NOT equipped with keyless entry:
  • Press and release the programming button on the EVO-CHR.
  • Confrim that the button clicks to ensure that it is not stuck against the case.
  • The LED will turn OFF to indicate that the programming is complete.
  • If the EVO-CHR is unplugged before this step is complete, restart the programming sequence from step 1.


Related FAQs

17 Dec 2009 Security light comes on with EVO-CHR and THAR-CHR2.

This only applies to the EVO-CHR when using the THAR-CHR2 T-harness on non TIP-Start vehicles. The security light will come on when the vehicle is remote-started and will remain on after a key-takeover and the remote-start...

[Rating: 10/10] Read FAQ

29 Dec 2009 Factory alarm is triggered when remote starting with EVO-CHR.

The factory alarm is triggered when the vehicle is remote-started when using an EVO-CHR. The EVO-CHR was programmed without indicating that the vehicle has a factory alarm and will not disarm the factory alarm during remo...

[Rating: 10/10] Read FAQ

5 May 2011 Factory alarm triggers when remote-starting with EVO-CHR.

The factory alarm triggers when remote-starting and the unlock-before/relock-after remote-start programming option has been enabled on the remote-starter programming options - but unlock/relock does not work. The EVO-CHR...

[Rating: 10/10] Read FAQ

30 Nov 2009 UltraStart will not crank during remote-start with EVO-CHR.

The UltraStart will send a very brief crank signal but immediately shuts down. When the UltraStart is used with the EVO-CHR the crank signal duration is not long enough to effectively start the vehicle, so the vehicle wil...

[Rating: 9/10] Read FAQ

[Products] Affected Products

This FAQ relates to the following products.

EVO-CHR

[Rate] Rate this FAQ

Did you find this article useful? Rating this article will not interrupt or redirect this page.


No Rate Article Yes